Lifted Toyota Hilux SR5 Cruiser with bull bar, winch and Dobinsons suspension at 360 4x4

How to Choose the Right Suspension for Your 4x4 (And Why Spring Rating Matters)

Walk into any 4x4 shop and ask for "heavy duty" springs and you'll probably walk out with them. But heavier isn't always better. The wrong spring rating is one of the most common reasons we see utes and 4WDs that sit wonky, ride like a brick, or sag at the back the moment the canopy goes on.

The right suspension is the one matched to your vehicle, your accessories and how you actually use it. Here's how to get it right.

1. Start with what your vehicle carries every day

Before talking lift heights or brands, work out the weight your suspension has to hold up most of the time. Think about:

  • Front end: bull bar, winch, driving lights, under-body protection, second battery under the bonnet
  • Rear end: canopy or tray, drawers, fridge, water tank, tools and gear, long-range fuel tank, spare wheel carrier
  • Regular extras: towing, roof racks and rooftop tents, camping gear

If you're not sure, take it over a public weighbridge loaded the way you normally drive. It's the single best way to pick the right springs.

2. Too heavy: the overrated leaf spring problem

This is the big one. A lot of people fit 300–600 kg rated leaf springs "just in case" when the tray is empty most of the week. A spring only settles to its designed height when it's carrying the load it was built for. Without that weight on it, you get:

  • Uneven ride height: the rear sits much higher than the front, giving a nose-down rake that looks off and throws your headlights into the ground
  • Harsh, bouncy ride: the rear skips over corrugations and potholes instead of soaking them up
  • Less grip: an unloaded stiff rear unweights the tyres, so you lose traction in the wet, on gravel and off-road
  • Worse braking and handling: less rear tyre contact means less control when it matters

Bottom line: if your ute isn't carrying the weight, don't buy springs rated for it.

3. Too light: the sagging problem

The opposite is just as bad. Fit light-rated springs and then load up a canopy, drawers, fridge and tow a trailer, and you'll see:

  • Rear sagging below the front, with headlights pointing at the sky
  • Bottoming out on the bump stops over bumps
  • Light, vague steering because weight shifts off the front wheels
  • Springs that tire and lose height early

4. Don't forget the front coils

A steel bull bar and winch can easily add 80–100 kg or more over the front axle. Standard coils will sag under that, killing your lift and leaving the front sitting low. If you're running a bar and winch (or plan to), you need coils rated for it. If you're not, heavy-duty coils will sit too high and ride hard, the same problem as overrated rear leaves.

5. Constant load vs occasional load

Rate your springs for the constant load, the weight that's on the vehicle nearly all the time.

For occasional loads, like a big camping trip or towing the boat a few weekends a year, there are better options than over-springing:

  • Helper airbags let you add support when you're loaded and let it out when you're not
  • Factor in towball weight: a trailer puts roughly 10% of its weight on your towball, so a 2,500 kg caravan adds around 250 kg to the rear. If you tow constantly, that needs to be part of the spring choice.

6. Match your shocks to your springs

Springs hold the weight, shocks control it. A heavier spring needs a shock valved to control it, or you'll get bounce and wallow. Quality kits pair the shocks and springs so they work together, which is why we recommend buying them as a matched kit rather than mixing and matching.

7. Lift height and compliance

More lift isn't automatically better. Bigger lifts change your steering geometry, driveshaft angles and centre of gravity, and in New Zealand larger modifications can need LVV certification to stay WoF/CoF legal. We'll talk you through what's legal for your vehicle and what each option means for ride and handling.

Quick guide: which setup suits you?

Typical examples only. Exact ratings vary by vehicle and brand, so talk to us before you buy.

Your setup Front coils Rear leaf springs
Daily driver, no bar or winch, light loads Standard rating Standard / light (around 0–200 kg constant)
Bull bar + winch, mostly empty tray Heavy-duty (bar & winch rated) Light to medium (0–200 kg constant)
Bull bar + winch, canopy, drawers, fridge, tools Heavy-duty (bar & winch rated) Medium to heavy (around 200–350 kg constant)
Bull bar + winch, fully kitted tourer or work ute with tool boxes, carrying heavy loads on the tray 100% of the time Heavy-duty (bar & winch rated) Heavy (400 kg+), consider helper airbags

How we spec your suspension at 360 4x4

At 360 4x4 we don't sell one-size-fits-all. When you come to us we'll:

  1. Ask what's on your vehicle now and what you're planning to add
  2. Ask how you use it: daily commute, work, towing, touring, off-road
  3. Recommend the right front coil and rear leaf rating, shocks and lift height for your setup
  4. Fit it in our Oxford workshop and check the ride height is spot on

Our suspension kits (including our Dobinsons-based kits) and leaf spring packs come in a range of ratings, so we can match the kit to your vehicle instead of just selling the heaviest option.

Not sure what rating you need? Get in touch at sales@3604x4.co.nz or call into our Oxford workshop. We're open weekdays 9am–5pm and Saturdays 9am–12pm by appointment only.

Back to blog